ValueHD Corporation
45
NOTE！
If router not support UPnP function, please set up router port mapping.
1.1.2 Router Port Mapping Setup:
Take TP-Link Router as example, in the router interface, select "Transit rule"--"Virtual server"--add a
new mapping port into the router list, as below:
Server port number: 80 (as default)
IP address: the IP address of the monitoring computer (here take 192.168.1.126 as example)
Protocol: ALL
State: Effective
Click "Save" to confirm, the mapping list will appear.
1.2 IP camera setting
1.2.1 Set DNS:
If allocate IP address manually, must set DNS to IPC, then IPC can be visited by dynamic DNS. Setup as
following:
1) After login camera via IE web browser (or other web browser)--click "Network Settings" --"Basic
Settings", shown as below:
To Next Page
Loading...
