Couple the FunTrain
Follow these steps to attach the FunTrain to a
Fun2Go with a ball coupling:
1. Lift the lever of the ball coupling [A]
over the tow ball [B].
2. Hook the safety cable [C] behind the
tow ball and into the bracket [D], as
shown.
3. The ball coupling is securely attached
to the tow ball when the indicator [E]
is in the green area with the "OK" sign.
4. Make sure to fold up the support
wheel after coupling. First, release the
locking bolt [F] by pulling it out.
5. Finally, fold up the support wheel until
the locking bolt clicks back into place
with an audible sound.
Uncouple the FunTrain
1. Unlock the locking bolt [F] of the support wheel by pulling it out.
2. Fold out the support wheel until the locking bolt [F] audibly clicks back into place.
3. Release the break cable [C] so that it is no longer hooked under the bracket [D].
4. Lift the lever and then lift the ball coupling off the tow ball.
Beware that the safety cable comes off the towing ball together with the trailer coupler.
To Next Page
Loading...