Vanatoo TRANSPARENT ONE ENCORE PLUS - User Manual

Quick Start Guide
VANATOO
®
TRANSPARENT ONE ENCORE PLUS
™
POWERED SPEAKERS
™
1
2
Unpack Your System
1) Active speaker
2) Passive speaker
3) 2 Grills
4) IR remote control
5) Optional isolation feet
6) USB A to USB B cable
7) 3.5 mm to 3.5 mm cable
8) Four conductor
speaker wire
9) 3.5 mm to RCA “Y” cable
10) AC power cord
11) Quick Start Guide and a
Safety Sheet
Connect the Speakers
TURN OVER
1
7
9
10
8
2
4
The included speaker interconnect cable with screw-on collar
connectors makes this quick and easy.
6
3
Connect Power
1. Make sure the power switch (2) is in the OFF position.
2. Plug the AC power cord into the active speaker.
3. Plug the AC power cord into the power outlet.
4
Connect Your Audio Source
Turn the volume controls on the speaker (1) and on the audio
source both to minimum.
1. Analog (3) — Connect your source using the included
using 3.5mm to 3.5mm cable or 3.5mm to RCA cable as
appropriate for your source component.
2. Digital Coax (4) — Connect your source component using a
75 ohm digital coaxial RCA cable.
3. Optical (5) — Connect your source component to the
Vanatoo T1E Plus using a Toslink optical cable.
4. USB (6) — Connect your computer to the T1E Plus using
the supplied USB A to USB B cable. Select the Vanatoo
T1E Plus in your computer’s audio settings.
5. Bluetooth —
a. Press and release the “Pair-Prog” button (7) on the
rear of the active speaker, or press “Enable” and
then “BT Pair” on the remote control. The bluetooth
interface will remain in pair mode for 2 minutes.
b. Ensure Bluetooth is turned-on on your source
device and pair with the Vanatoo T1E Plus.
c. Ensure your source device is connected to the
Vanatoo T1E Plus over Bluetooth and play music!
PAIR-PROG
100-240V-50/60 Hz 148W
SERVICE
4
3
7
8
9
5
6
1
2
5
3

Summary

Unpack Your Vanatoo System

Connect the Speakers

Connect Power

Connect Your Audio Source

Analog Audio Connection

Connect source using 3.5mm to 3.5mm or 3.5mm to RCA cable.

Digital Coax Audio Connection

Connect source using a 75 ohm digital coaxial RCA cable.

Optical Audio Connection

Connect source using a Toslink optical cable.

USB Audio Connection

Connect computer via USB A to USB B cable. Select T1E Plus.

Bluetooth Pairing and Playback

Press Pair-Prog, enable Bluetooth on source, and pair.

Designate Left-Right Speaker

Install the Grills

Listen to Music

Remote Control Usage

Optional Settings Overview

Vanatoo TRANSPARENT ONE ENCORE PLUS Specifications

General

Subwoofer Output	Yes
Remote Control	Yes
Type	Active
Power Output	100W (50W per speaker)
Frequency Response	48Hz - 20kHz
Connectivity	Bluetooth, USB, Optical
Tweeter	1-inch
Bluetooth Version	Bluetooth 5.0
DAC	Built-in high-quality DAC