Vanderbilt ACT 5 - User Manual

ACCESS CONTROL
ACT 5 DIGITAL KEYPAD
Installation, Operating Instructions & Quick Guide
INSTALLATION NOTES
• Always remember to factory default the controller before you start programming.
• Always remember to place the supplied Varistor across the terminals of the door strike
coil to protect the relay contacts.
• Never use the onboard relay to switch AC mains voltage.
An external relay isolated electrically from the ACT5 should be used for this purpose.
• Don’t forget to change the programming code to something known only to yourself.
IMPORTANT
As with any access control system, always ensure that there is an alternate means of escape
in the event of the unit failing to operate due to power loss or in the event of re.

Vanderbilt ACT 5 Specifications

General

Brand	Vanderbilt
Model	ACT 5
Category	Keypad
Language	English