ACT5 Digital Keypad Programming
To enter programming mode:
Press the X button followed by the engineering code (initially all 9999)
The LED will ash Amber while in programming mode . If X is pressed at any
time or no key is pressed within 30 seconds, programming mode is exited.
Changing Codes (from programming mode):
Enter 0 (Change codes)
0-9, ☑ (user number 0-9, ☑ = programming code)
0000-9999 (4 digit code – 0000 deletes user)
Default user codes : Programming = 9999, User 1 =1234,
Toggle Relay (from programming mode):
Enter 1 (Toggle output)
0-9, (user number 0-9)
0, 1 (0 = Toggle Relay, 1 = Relay Timed)
Setting the Relay active time (from programming mode):
Enter 2 (Set Relay active Time)
0 (Relay Timer) {Buzzer sounds indicating timing…
wait required period}
☑ (Stop timing) {Buzzer stops — timer set}
Setting the Backlight (from programming mode):
Enter 40 (Set Pemanent Backlight)
0, 1 (0 = Backlight always o, 1 = Backlight always on)
41 (Set Auto Backlight)
0, 1 (0 = Auto Backlight o, 1 = Backlight on if key pressed,
Permanent Backlight overrides Auto)
Restoring Factory Defaults (from programming mode):
☑ ☑ ☑ (Factory Defaults Restored & Keypad exits programming mode)
If the programming code has been forgotten.
1. Remove the power from the unit.
2. Remove link LK1.
3. Apply power to unit.
4. Wait 3 seconds and remove power again.
5. Replace link LK1.
6. Restore power and proceed with programming.
Note: The keypad will not operate correctly without LK1 in place.
ACCESS CONTROL
To Next Page
Loading...
