VANMOOF X3 - The Toolbox Contents

7
BUILD YOUR BIKE
ToolboxFront wheel stand
1.1 To take the bike out of the box, gently
pull the yellow strap.
1.2 Remove (and recycle) all protective
packaging. Squeeze the tab on the
cable ties to remove them without
cutting – you can reuse them later.
2.1 Take the toolbox out of the triangular
front wheel stand – you’ll nd it at the
front side of the stand.
2.2 Make sure you detach the wheel from
the bike frame.
1. Take the bike out of the box
2. Get your toolbox ready