Vantec CB-U300GNA - Windows Driver Installation; Mac OS X Driver Installation; Hardware Verification; Verifying Windows Installation

CB-U300GNA Page 6
2.2.1 Installation for Windows
1. Insert the provided CD into your disk drive.
2. At the Windows Desktop, click Start, then Run.
3. Type D:\CB-U300GNA\Windows\Setup.exe, then click OK.
(Change D: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation.
2.2.2 Installation for Mac OS X
1. Insert the provided CD into your CD-ROM drive.
2. Navigate to “CD-Drive\CB-U300GNA\Mac” folder.
3. Double click the “AX88179.dmg” file to launch the installer.
4. Follow the instructions on screen to install the driver. After driver
installation is complete, you must restart your computer.
2.3 Hardware Verify
2.3.1 Verifying for Windows
1. Click on the “Device Manager” tab in the Windows Control
Panel.