Vantec UGT-PC210 - Hardware Installation; Installation Steps; Driver Installation; Windows XP;2000 Driver Setup


UGT-PC210Page4
Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCI slot.
4. To install the card, carefully align the card’s bus connector
with the selected PCI slot on the motherboard. Push the
board down firmly.
5. Replace the slot bracket’s holding screw to secure the card.
6. Replace the computer cover and reconnect the power cord.
Driver Installation
For Windows® XP/2000
Windows® XP/2000 will automatically detect and install the
correct driver for the 5-Port USB 2.0 PCI Host Card.
However, please ensure you have the latest Service Pack
Installed.
For Windows® XP
z Windows® XP Service Pack 1 or later
For Windows® 2000
z Windows® 2000 Service Pack 4 or later
For Windows® Server 2003/Vista