- 13 -
4.3 Low Voltage Protection
In the full-screen interface, there will be 4 modes of display.
Sliding the screen left and right to switch the front camera
preview picture, the cabin camera preview picture, the
rear camera preview, and the front+cabin+rear camera
preview picture displayed on the same screen.
2.
The M3 docking station has a power supply identification
function, with M3 supporting hardwire kit use, which can
identify the car battery voltage. The car mode refers to the
protection voltage setting. The protection voltage has 3
gears, namely 11.8V, 12V, and 12.4V. If the protection
voltage of 11.8V is set, when the car battery reaches 11.8V,
the docking station will automatically cut off the power
supply to protect the Car battery.
Note：
The low voltage protection function does not support 24V
car batteries for the time being.
Please use the hardwire kit for this function.
EN
EN
EN
EN
9-1
Fri
00:10:15
9-1
Fri
To Next Page
Loading...
