Vantrue OnDash N2S - Auto LCD OFF; Loop Recording

Frequency: Press button to change the options: 50Hz/60Hz.
System Info: Press to check the current firmware version. (System
Info)
Default Settings: Press button select and to reset the device
back to stock factory settings. Press the button to exit and complete
the setup.

Speed Unit: Press to select either KM/H or MP/H.
- 11 -
or
OK
4.2.3 Files
Review and delete videos stored in the file folders.
Event: Critical event videos detected by G-Sensor activity or manually
locked by user.
Normal: Standard videos recorded.
All: All the standard videos, critical event videos recorded.
OK OK
OK
OK
Open the interface, navigate to “System Setup” > “Time & Date”, and
press button to set the date/ time. Navigate to select date
and time values.
Press to confirm and proceed. To finish setup, just press the button
to exit.
NOTE: Date format is MM/DD/YY with the time in 24 hour format.
4.3 Set Date/Time
or
OK
OK
•
•
•
•
•
•
•
•