- 16 -
Infrared LED Auto
Infrared LED On
Infrared LED Off
A
Critical event detection is triggered by the G-Sensor (Gravity Sensor) and
will auto-detect vehicle impacts and collisions. This will cause the camera
to protect the current video clip from being overwritten by locking it and
saving to the “Event” folder.
The vehicle driver can also manually lock the current video recording
session by pressing the Button. A key icon will appear at the center of
the screen.
The G-Sensor sensitivity is adjustable with 5 settings: 1, 2, 3, 4, 5, and off – it
is set to 3 by default. The G-Sensor can also be deactivated in “Record
Setup”>“G-Sensor”.
The Collision Detection sensitivity can be adjusted by the following three
settings: Low, Medium and High. Please go to “Record Setup” > “Parking
Mode”> “Collision Detection” to change as needed.
4.8 Event Recording
Event videos are stored in the “Video/Event” folder, and cannot be
automatically overwritten.
3840x2160P 25FPS
NOTE: The camera will auto overwrite old Event videos once the Event
folder has accumulated 30% of the card capacity. Please regularly
transfer important videos to your PC or another storage location (e.g.
external hard drive). To maintain good read/write performance, the
microSD card should better be formatted once a month.
To Next Page
Loading...
