- 19 -
When the Collision Detection has been turned on, and no The Collision
Detection sensitivity can be adjusted by the following three settings:
Low, Medium and High. Please go to “Record Setup” > “Parking
Mode”> “Collision Detection” to change as needed.movement is
detected after 5 minutes of recording, then Collision Detection is
activated with a Collision Detection icon at the bottom right corner of
the screen, and the camera automatically to turn off. Full frame
recording will be triggered by the Collision Detection sensor. Once it
detects vehicle impacts or collision, it will auto turn on and start auto
4.10.2 Collision Detection + Motion Detection Triggered
1440P+1440P 30FPS
4-1-2021
1440P+1440P 30FPS
4-1-2021
When the Collision Detection + Motion Detection has been turned on,
this is represented by a Collision Detection + Motion Detection icon at
the bottom right corner of the screen.
If no movement is detected after 5 minutes of recording, there will be
an orange P icon appears in the center of the screen which means
Parking Mode is activated. Once the camera detects movement, it will
start auto-recording; Once you power off the camera, full frame
recording will be triggered by the Collision Detection sensor. Once it
detects vehicle impacts or collision, it will auto turn on and start auto
recording; it will stop recording after 30 seconds of inactivity.
recording; it will stop recording and auto off again after 5 minutes of
inactivity.
To Next Page
Loading...
