Vantrue OnDash N2S - Low Bitrates Recording

- 18 -
Parking Mode operates as a sentry function under different situations.
To activate Parking Mode, go to “Record Setup”> “Parking Mode” ,
press and select the following options: Collision Detection, Collision
Detection + Motion Detection, Motion Detection, Low Bitrates Record-
ing, OFF.
When entering parking mode, there will be a notification appear on
the screen, pls press button to confirm.
4.10 Parking Mode (Constant Power Supply Needed)
If you set the Parking Mode OFF, the camera will enter normal recording
mode.
OK
OK
OK
Note: When parking in the
hot summer sunlight,
please use the collision
detection triggered
parking mode
4.10.1 Collision Detection Triggered
When the Collision Detection has been turned on, and no The Collision
Detection sensitivity can be adjusted by the following three settings:
Low, Medium and High. Please go to “Record Setup” > “Parking
Mode”> “Collision Detection” to change as needed.movement is
detected after 5 minutes of recording, then Collision Detection is
activated with a Collision Detection icon at the bottom right corner of
the screen, and the camera automatically to turn off. Full frame
recording will be triggered by the Collision Detection sensor. Once it
detects vehicle impacts or collision, it will auto turn on and start auto
recording; it will stop recording and auto off again after 5 minutes of
inactivity.