Vespera Pro Instruction Manual v1.0 EU US CA 2023-12 8
press the "confirm filter installation" button
follow application instructions to properly position the instrument
press the "confirm arm orientation" button for Vespera Pro to start the solar observation
10. If improperly assembled or defective
the "confirm filter installation" button will not be available (dimmed)
the filter icon will not appear under the product image, "no filter detected" will appear instead
remove the filter and reassemble. If the problem persists, contact support
Stopping the observation
1. Remove the AC021 solar filter by pressing the button provided for that purpose.
2. Put the cover back on and press the "close arm" button.
Note:
• There is a visual marker with the letter S located on the inside of the filter for easy
identification when the filter is not mounted on the product.
• For optimal storage, we recommend storing the filter in its original plastic box.
• Cleaning and maintenance must be performed with caution. Only use wipes specifically
intended for optical lenses.
VII. Care and maintenance
Vespera Pro is an optical instrument, it is therefore fragile and requires a lot of precaution during its use.
The front lens must not come into contact with fingers, cloths, eyeglass cloths, liquids etc.. Only specific
wipes for optical lenses can be used.
The plastic shell can be cleaned with a soft cloth and soapy water.
Do not open the device under any circumstances. Do not attempt to disassemble, modify or repair the
device, as this will void the warranty and may cause the instrument to malfunction. otherwise the warranty
may be void and the instrument may malfunction.
If any issue arises, please contact our Support Department at the following numbers : +33 4 84 98 00 21
(Europe) or +1 (646)-956-5933 (US/CA) or via WhatsApp at +33 6 70 34 09 03. You can also reach us by
email at support@vaonis.com.
To Next Page
Loading...
