VTE600-Combo
Intelligent Li-Po/LiFe Battery Pack Balance Charger Product Instructions
Charging Process Indications:
Only connect the power, the
side selector switch on Li-
Po position
Please charge Li-Po Batteries only
Only connect the power, the
side selector switch on
LiFe position
Please charge LiFe Batteries only
1CELL LED RED,
2CELL & 3CELL LEDs:
BLUE(Li-Po), or GREEN(LiFe)
Normal charge by 1S Battery
1CELL & 2CELL LEDs RED,
3CELL LEDs:
BLUE(Li-Po), or GREEN(LiFe)
Normal charge by 2S Battery
Three cells normal charge
Normal charge by 3S Battery
1CELL LED RED/BLUE(Li-Po)
or RED/GREEN(LiFe),
2CELL & 3CELL LEDs:
BLUE(Li-Po), or GREEN(LiFe)
80%~90% charged for 1S Battery
1CELL & 2CELL LEDs
RED/BLUE(Li-Po) or
RED/GREEN(LiFe)
3CELL LEDs:
BLUE(Li-Po), or GREEN(LiFe)
80%~90% charged for 2S Battery
Three cells 80%~90%
normal charge
1CELL~3CELL LEDs
RED/BLUE(Li-Po) or
RED/GREEN(LiFe)
80%~90% charged for 3S Battery
1CELL~3CELL LEDs BLUE(Li-
Po), or GREEN (LiFe)
Fully charged for 1S Battery
1CELL~3CELL LEDs BLUE(Li-
Po), or GREEN (LiFe)
Fully charged for 2S Battery
1CELL~3CELL LEDs BLUE(Li-
Po), or GREEN (LiFe)
Fully charged for 3S Battery
Notice:
Please plug battery pack into charger after connecting charger with the mains; confirm +/- polarity of battery pack.
The charger has heat dissipation, do not put any thing on it (such as: plastic), otherwise it will affect the charge for inner
temperature is too high and not easy to dissipate heat. The circuit of inner will self-reduce output power and prolong time of
charge. Normal temperature depend on 30℃～50℃. The charger will stop working after 60℃, LED will be flash.
If charger is not in using, please ensure that charger is not connected with power.
To Next Page
Loading...