VAPEX TECH VTE600-Combo - Charge Time Estimates and Warnings; Battery Charge Time Table; Usage Warnings and Precautions; Usage and Environmental Notices

VTE600-Combo
Intelligent Li-Po/LiFe Battery Pack Balance Charger Product Instructions
Charge Time Table
Battery style and capacity
Charge time
Charge time
Li-Po 600mA
4.2-12.6V
LiFe 600mA
3.65-10.95V
Li-ion
Li-Po
LiFe
6600mAh
About 12 hours
About 12 hours
5000mAh
About 9 hours
About 9 hours
4000mAh
About 7 hours
About 7 hours
3300mAh
About 6 hours
About 5 hours
2200mAh
About 4 hours
About 4 hours
1600mAh
About 3 hours
About 3 hours
1300mAh
About 2.5 hours
About 2.5 hours
1000mAh
About 2 hours
About 2 hours
800mAh
About 1.6 hours
About 1.6 hours
450mAh
About 0.8 hours
About 0.8 hours
◆ Above battery charge time depend on ambient temperature 10 ℃ to 30 ℃. Charging time may be different from different
brand batteries
Warning:
Only suitable for Li-ion, Li-Po or LiFe Batteries.
Do not charge for other types batteries (such as alkaline or carbon batteries), otherwise will cause battery heat, leak, or break,
even harm to person or property. It belongs to user’s responsibility.
Keep away from children when charge, do not let children play with the charger.
Operate charger properly avoid power collision.
The product is seal covered, do not disassemble it, or the charger will be useless, even lead to danger (fire/explode). All
responsibilities belong to user.
Notice:
The charger is for indoor use only, do not expose in rain or snow.
Finish charge or not in use, remove charger from power supply.
Do not let the charger fall to the ground, or put heavy things above it, or bang it.
Children can use the charge with guide of adult.
The charge operation temperature is 0℃-40℃, to get ideal electricity capacity, please charge under temperature betweens 10℃-
30℃.
After high-power discharge, perfect to carry on the charge in 4 hours later, at the same time is quite good charge effect,
Otherwise it can reduce the charge efficiency, even has certain influence to the battery life.
Do not charge if the temperature of battery is higher than ambient temperature for than 5℃, it should better wait for the battery
temperature to reduce to the ambient temperature.
The charger only suitable Li-Po or LiFe, it cannot use for Ni-MH or Ni-Cd.
If there is not any display on charger, please check whether input or output is opposite connected or not.
Please prevent Lithium battery from over charge, or charge effect will be reduced, what worse, the lithium battery will be not
charged in anymore.
Specifications
Input voltage: 85V-240V, 0.2A Max
Input frequency: 50/60Hz
Cut-off voltage For Li-Po Battery: DC 4.20V±0.015V / 600mA±100mA * 3
For LiFe Battery : DC 3.65V±0.015V / 600mA±100mA * 3
Operation temperature : 0℃ to 40℃
Dimension: 101MM * 61MM *34MM
Weight: 155g