What to do if my Vari 401511 shows error E01?
If the Vari Indoor Furnishing desk displays 'E01', it indicates an overcurrent issue, usually from overloading. To resolve this, remove some items or redistribute the weight more evenly across the surface, as the desk's rated loading is based on average distribution. Then, reset the system following the reset instructions. Contact Vari support if the error continues.
What to do if my Vari 401511 Indoor Furnishing shows error E07?
If your Vari Indoor Furnishing displays 'E07', try disconnecting and reconnecting the cable. Then, reset the desk by following the reset (RST) instructions. If the error message remains, contact Vari support for further assistance.
How to reset Vari 401511?
If your Vari Indoor Furnishing displays 'RST', ensure all cables are securely connected. Then, press and hold the down button on the control panel for about 5 seconds until 'RST' flashes on the screen. Release the down button, and proceed with the following steps. If 'RST' is already flashing, press and hold the down button until the desk reaches its lowest height, raise it slightly, and wait for the height number to display. Do not release the down button until the height number is shown. The desk should now be ready for use.
What to do if my Vari 401511 shows error H01?
If your Vari Indoor Furnishing displays 'H01', stop adjusting the desk and wait for 20 minutes before resuming.
General| Brand | Vari |
|---|---|
| Model | 401511 |
| Category | Indoor Furnishing |
| Language | English |
Attach legs to desktop frame, ensuring motor leg is on the correct side for control panel.
Secure both legs using M6 washers, M6-14 bolts, and M6 Allen key.
Install and secure transmission shaft, aligning hex shafts and tightening nuts.
Secure transmission shaft cover using push-in rivet pins.
Secure both feet to the legs using M10-25 bolts and M10 Allen key.
Slide control panel into its bracket on the front edge of the desk.
Slide control box into its bracket on the desk frame.
Connect control panel, motor, and power cords to the control box.
Flip the desk onto its feet and connect to a power source.
Configure desk settings like One-Touch or Constant-Touch operation.
Toggle display between inches and centimeters for height measurements.
Program up to 4 height preferences by adjusting desk height and pressing 'M'.
Define custom upper and lower height limits for the desk's movement range.
Recalibrate desk height if the display does not match physical measurement.
Lock the control panel to prevent accidental adjustments.
Unlock the control panel to allow adjustments after it has been locked.
Address desk issues like no response or slow rising by resetting.
To Next Page
