3
Installation Procedure
Do’s
1. Mount the thermostat at eye level
2. Read the instructions fully to get the best from our product.
Don’ts
1. Do not install near a direct heat source as this will affect
the workings of the thermostat
2. Do not push hard on the LCD
Installation
The thermostat should be mounted in a 35mm (min) deep back
box.
Step 1 - Carefully separate the front half of the thermostat
from the back plate by placing a small flat head terminal driver
into the slots on the bottom face of the thermostat.
Step 2 - Place the thermostat front somewhere safe. Terminate
the thermostat as shown in the diagram at the back of this
booklet.
Step 3 - Clip the front of the thermostat to the back plate,
taking care not to bend or damage the connection pins
To Next Page
Loading...