3. Suitable For Use On Model M27-1
Use a No.2 (M4 wrench) tool to unscrew the 4 bolts from the stem cover and
rotate the handlebars so they are perpendicular to the bike frame; tighten
the stem cover against the handlebars and install the 4 bolts back into the
stem; tighten the screws again using a No.2 (M4 wrench) tool.
(2) Installation Of Front Wheel
Suitable For C20-1/C26-2/M26-3/M26-2/M27-1/C20-1 Pro/S26-1/
M24-1 Model
Use a No.8 (M17 wrench) tool to loosen the fork retaining bar and remove it
(this accessory is to prevent the fork from deforming during delivery).
To Next Page
Loading...
