Varytec Colors SonicStrobe - Page 31

Sound control mode can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX. In this operating mode, the device responds to acoustic pulses which are
recorded by the integrated microphone.
n Briey press [MENU] repeatedly until the display shows ‘SoUn’ . Conrm with [ENTER].
Use and to select between ‘SoXX’ and ‘SeXX’ . Conrm with [ENTER].
n Use and to select the desired show programme ( ‘So00’ … ‘So16’ ) or specify the sensi‐
tivity for the built-in microphone for sound control in a range from ‘SE00’ (low sensitivity)
… ‘SE99’ (high sensitivity). Conrm with [ENTER].
Auto mode can only be activated when the unit is operating in stand alone mode or as master
in a master / slave combination. This setting is only relevant if the device is not controlled via
DMX. In auto mode, 17 dierent show programmes are available, which run with adjustable
speed.
n Press [MENU] repeatedly until the display shows ‘Auto’ . Conrm with [ENTER].
Use and to select the desired show programme ( ‘Au00’ … ‘Au16’ ) and conrm with
[ENTER]. The display shows ‘SP’ .
n Use and to set the running speed of the programme in a range from ‘SP00’ (slow) …
‘SP99’ (fast) and conrm with [ENTER].
Operating mode ‘Sound control’
‘Automatic mode’
Operating
Colors SonicStrobe
31
stroboscope