107Instruments, controls
Acknowledge warning messages as
described on page 98. Unacknowledged
warning messages can be re-displayed
later.
Warning messages:
Remote Control
Battery
check
Remote control battery voltage too low –
see page 32.
Brakelight switch
check
Fault. Brake light not illuminating when
braking occurs. Have cause of fault
remedied by a workshop immediately.
If there is a fault in the lighting system, the
respective location of the fault is displayed
as text, e.g.:
Brakelight
check right
Interruption of power supply
Stored warning messages appear on the
display one after the other.
Warning buzzers
When starting the engine or while driving:
z If driver’s seat belt is not fastened.
z If a door or the luggage compartment
has not been closed correctly when you
set off.
z Once you have reached a certain speed
if the handbrake is applied.
z If a specified maximum speed is
exceeded.
z With Easytronic 3, if A, M or R is selected
while the engine is running and the
driver’s door is opened but the footbrake
is not depressed.
z Warning signal sounds three times if the
Flex-Fix system is extended 3 and
reverse gear is selected.
When the vehicle is parked and the
driver’s door is opened:
z When the key is in the starter switch.
z With parking lights or dipped beam on.
z With Easytronic 3, if the handbrake is
not applied and no gear is selected when
the engine is off.
Brakelight
check right
OK
Ofrecido por www.electromanuales.com
To Next Page
Loading...
