Taking care of your machine
Changing the belt
IMPORTANT: Unplug and switch o vacuum cleaner before maintenance or troubleshooting checks
Using a crosshead screwdriver,
remove 3 screws from the side
of the oor head.
Remove the end cap belt cover. Remove the brush bar location plate
to gain access to the belt.
Replace the old belt, ensuring the teeth
are fully engaged with the cogs.
Turn the TurboTool over and
slide o the locking ring.
Detach lower housing
and remove.
Using a pair of scissors,
cut any hair or debris free
from around the brushes.
Removing blockages from the TurboTool
To re-assemble the
TurboTool, ensure that the
tabs are engaged and pivot
the lower housing closed.
Slip the locking ring over the
neck of the TurboTool and
into the groove to nish.
*Not applicable to some models.
To Next Page
Loading...
