Before you begin cleaning
Do not saturate your carpet.
• Test for colourfastness – Wet a white absorbent cloth with the solution. In a small, hidden area of your carpet and
upholstery, gently rub the surface with the dampened cloth. Wait ten minutes and check for colour removal or bleed with
white paper towel or cloth. If your carpet has more than one colour, check all colours.
• When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture is too heavy to move, place
and curtains.
• Test your carpets/rugs/upholstery - Run the machine over a small hidden area. If no pile distortion occurs continue
cleaning over required area.
Operating your carpet washer
Remove clean water tank.
Max
!
IMPORTANT: Only use Vax carpet cleaning solution. Using other solutions may cause excess foaming.
:TNATROPMI (max 40°C). Filling the tank with hot
or boiling water may damage the machine and invalidate your warranty.
:TNATROPMI
before returning tank to unit.
CAUTION:
The carpet washer is a very powerful unit. Before plugging the cord into the electrical outlet, make sure
6
How To Use
vax.com.au
To Next Page
Loading...
Need help?
General
