Vax Dust & Vac Cordless HF86-DV-B - What to do if it goes wrong; Is there an accessory missing?; Why wont my Dust & Vac turn on?; Why wont my Dust & Vac pick up?

What to do if it goes wrong
Problem
CAUTION: To reduce the risk of personal injury, unplug the Dust & Vac from charger before performing
maintenance/troubleshooting checks.
Is there an
accessory missing?
• Check the ‘This pack contains’ panel on the box to make sure the part is
included with your machine.
Why won’t my Dust &
Vac turn on?
• Ensure the handle is tted correctly and pushed fully on to the main body.
• Battery may not be fully charged. If using the Dust & Vac for the rst time
the initial charge should be 24 hours. The charging light will illuminate
when charger is connected and charging, once fully charged the
illuminating light will go out
.
Why won’t my Dust &
Vac pick up?
• Empty dirt container, remove and wash lter allowing
24 hours to dry before retting.
• Dirt container may not be tted correctly. To ret the dirt container tilt so that
the bottom aligns rst, and then gently push until it locks into place.
• Poor suction can be caused due to battery power becoming low and may
need to have a full re-charge.
• Clear any blockages from the machine.
Dust escaping from
the Dust & Vac
• Dirt container may be full and may need to be emptied.
• Filter may need to be washed please allow 24 hours to dry before retting.
• Clear any blockages from the machine.
Solution
Getting in touch
HF86-DV-B_Dust&Vac_Cordless_UG_[J1331]_PRINT_171014.indd 10 21/10/2014 10:52