Depress the release
button to remove the
dirt container.
Hold lter under warm running water (max
40° C) to rinse. DO NOT use soap/detergent.
Tap excess water out of lter.
Gently push the dry
lter back into the
dirt container.
Allow lter to COMPLETELY DRY for at
least 24 hours before retting into the
dirt container.
To ret the dirt container tilt so that the
bottom aligns rst, then gently push until
it locks into place.
Grasp the center
tab on the lter
and pull out of the
dirt container.
Shake and lightly tap
the lter against the
bin to remove dirt.
Maintaining your lter
24hr
Always disconnect the charger
from Dust & Vac before carrying
out any maintenance. Ensure lter
is fully dry (at least 24 hours drying
time) before retting into the dirt
container and is replaced every
6 months.
CAUTION
Taking care of your machine
NOTE: For best results tap out lter after every use and wash periodically.
Remove the machine
from charge.
Clearing a blockage
Depress the release
button to remove the
dirt container.
Check dirt air path is clear of
dust and debris above the dirt
container and below the base
of Dust & Vac.
Storage
Use storage hook to hang Dust & Vac
where it can easily be charged.
IMPORTANT: Store in a cool dry place.
HF86-DV-B_Dust&Vac_Cordless_UG_[J1331]_PRINT_171014.indd 9 21/10/2014 10:52