vax.co.uk
7
Operation
Refreshing carpets
To clean with steam detergent
IMPORTANT: When using on carpets, always ensure the velcro microfibre cleaning pad is properly attached
to the floor head.
Place unit into carpet
glider with pad attached.
To recline the unit place
foot on floor head and tilt
handle backwards.
To produce steam squeeze
the trigger in short bursts
to prevent overly wetting
carpets. Do not hold
down continuously.
NOTE: The detergent can be used on hard floor surfaces.
This product can be used with or without detergent and on different
floor surfaces. To use with detergent use the surface selector up and
down buttons to cloose desired setting for area you want to clean.
These settings are wood, tile, vinyl and carpet. Squeeze/release trigger
to dispense detergent. To use on carpet or to use your unit WITHOUT
detergent, select ‘Carpet.’
WARNING: Only use recommended Vax Steam Detergent.
Move the steam mop slowly
backwards and forwards
across the floor paying
particular attention to high
traffic areas.
Turn the dial on the front
of your unit to ‘Carpet’
setting.
Refreshing carpets
Place foot on outer
floorhead and gently pull
away main body to
remove the compact
scrub brush.
Move steam mop back and
forwards across the floor,
getting into corners and
awkward places.
To Next Page
Loading...
Need help?
General
