Vax HF86-DV-A - Taking Care of Your Machine

Depress the release
button to remove the
dirt container
Check dirt air path is clear of dust and debris above the
dirt container and below the base of Dust & Vac
Storage
Taking care of your machine Taking care of your machine
After use wrap power cord
around cord clips provided
Important: Store in a cool dry area
Important: DO NOT USE BLEACH or FABRIC SOFTENER. For best results, wash the microbre cloth after every use
Always switch o and unplug Dust & Vac
before carrying out any maintenance.
Ensure lter is fully dry (at least 24
hours drying time) before retting into
the dirt container and is replaced every
6 months.
NOTE
Switch o and unplug
Use storage hook to hang
Dust & Vac where it can
easily be stored
Depress the release button
to remove the dirt container
Hold lter under warm
running water (max 40° C)
to rinse. DO NOT use soap/
detergent. Tap excess water
out of lter
Gently push the dry lter
back into the dirt container
Allow lter to COMPLETELY
DRY for at least 24 hours
before retting into the
dirt container
To ret the dirt container
tilt so that the bottom
aligns rst, then gently
push until it locks
into place
Grasp the center tab on
the lter and pull out of
the dirt container
Shake and lightly tap the
lter against the bin to
remove dirt
Maintaining your lter
Maintaining your Microbre grab pad
Machine washable at warm temperature (40°C max).
Always use a mild detergent and lay at to dry completely
before re-using
For best results tap out lter after every use and wash periodically
Clearing a blockage
40°C MAX
07 08
24hr