Vax HF86-DV-A - What to Do if It Goes Wrong; Getting in Touch

• Check the ‘This pack contains’ panel on the box to make
sure the part is included with your machine.
• Ensure the handle is tted correctly and pushed fully on to
the main body.
• Check the fuse in the plug. Always replace the fuse in the plug
with a British 13amp fuse.
• Dirt container may be full and may need to be emptied.
• Filter may need to be washed please allow 24 hours to dry
before retting.
• Clear any blockages from the machine. (See page 8)
• Empty dirt container, remove and wash lter allowing
24 hours to dry before retting.
• Dirt container may not be tted correctly. To ret the dirt
container tilt so that the bottom aligns rst, and then gently
push until it locks into place.
• Clear any blockages from the machine. (See page 8)
SolutionProblem
What to do if it goes wrong Getting in touch
There is an
accessory missing
Dust & Vac will not
switch on
Dust & Vac won’t pick
up or poor suction
Dust escaping from
Dust & Vac
* Calls are charged at the UK local rate. Please make a note of the serial number and model number of the vacuum cleaner
before calling.
09 10