Press the dirty water
tank release latch and
pull the tank to remove.
Pull and lift the dirty water
tank clip to release the lid.
Lift the tank lid to remove.
Empty the dirty water over the sink. Rinse
the dirty water tank and lid under water
(max 40°C) to remove dirt/debris.
Clean the lter screen
located at the back of the
dirty water tank.
Emptying and cleaning the dirty water tank
To re-t, tilt the dirty water tank
and line the front of the tank up
onto carpet washer. Push back
until it clicks into place.
Using your machine
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT: Empty and rinse out clean and dirty water tanks and leave to air dry before replacing.
Do not leave solution stored in the tanks between uses.
To Next Page
Loading...
