Taking care of your machine
IMPORTANT: If the nozzle is tted incorrectly, this will cause poor dirty water pick up.
Remove both tanks and tilt
the carpet washer back.
Lift the nozzle release clip
and pull the nozzle forward,
separating the tabs on the
nozzle and carpet washer.
Rinse the nozzle under
water to remove dirt/debris.
To replace the nozzle, line
up the tabs on the nozzle
with the tabs underneath the
front of the carpet washer.
Push the nozzle down until
it clicks into place.
Removing and cleaning the nozzle
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
To Next Page
Loading...
