Washing hard oors
CAUTION: To prevent damage to wood oors and other hard oors, follow the ooring manufacturer's
cleaning recommendations. Inspect the oor surface for a worn nish, bare wood or separated joints.
It is not recommended to use the carpet washer on oors if any of these conditions exist. Test on an
inconspicuous area rst
IMPORTANT:
Hard oors should be dry vacuumed thoroughly before washing.
Before attaching the hard oor squeegee onto the carpet washer, either remove the tanks or make sure the tanks are
empty before lying the carpet washer on its back.
Using your machine
Pour the required amount
of solution into the tank.
Fill the clean water tank
with warm water
(max 40°C).
TIP
For best results, clean hard
oors in Quick Clean Mode
Lie the carpet washer on
its back and line up the
squeegee with the nozzle.
Hold the front of the squeegee onto the
edge of the nozzle and push the squeegee
under the nozzle until it clicks into place.