Using the pre-treatment wand
Using your machine
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Push the wand connector
into the solution tube port.
Plug into the mains and
press the On/O button
to switch on.
Press and hold the trigger
on the pre-treatment
wand, spraying evenly
over stubborn atains
Leave the solution for
10-15 minutes before
washing carpet.
Pour the required amount
of pre-treatment solution
into the tank.
Fill the clean water tank
with warm water
(max 40°C).
Turn the wash/rinse dial
to ‘wash’.
Pull down the accessory
hose connector cover.
To Next Page
Loading...
