17
Removing and cleaning the brushbar
To refit, loop the brushbar
through the belt and onto
the belt grip.
Line up the ‘right’ side
brushes with the base and
slide into place. Attach the
brushbar to the side brushes.
Pull and slide the right side
brushes together with the
brushbar. Remove the side
cap from the brushbar and
unloop the brushbar from
the belt.
Refit the belt guard and tighten the 2 screws.
Replace and tighten the 4 screws on the side
brushes and refit the rug guards, tightening the 4
screws to secure.
Attach the other side
of the brushbar to the side
brushes. Slide onto the side
of the base and into place.
Pull and slide the left side
brushes and remove the
side cap from the brushbar.
Using a crosshead screwdriver remove the 4 screws
on the side brushes and the top and bottom screws
from each of the rug guards (metal pins) to get
access to the brushbar.
Using a crosshead
screwdriver, undo the 2
screws and remove the
belt guard.
Using a pair of scissors,
remove any threads or hair
caught around the brushes.
Rinse under water to
remove debris.
MAINTENANCE & CLEANING
To Next Page
Loading...
