9
Filling the water/solution tank
Press the clean water/
solution tank release
button, pull and lift to
remove the tank.
Twist the water/solution
tank cap anti-clockwise
and remove.
Pour the required amount
of carpet cleaning solution
into the tank. Tighten the
cap before returning the
tank to the washer.
Fill the clean water tank
with warm water (max
40°C). Fill to the max fill line
for a Deep Clean, and fill to
the Quick Clean fill line for a
quick surface clean.
Tilt and line up the front of
the tank to the washer and
push the tank back until it
clicks into place.
USING YOUR MACHINE
IMPORTANT: Do not leave the solution stored in the tanks between uses.
NOTE: This machine has an auto mix tank so any solution not used can be poured back into the bottle.
To Next Page
Loading...
