10
Squeeze the trigger to
release the solution and
water mix.
Press the recline pedal and
pull the handle backwards.
For tough stains press
the boost trigger together
with the solution trigger to
release more water and
solution mix.
For best results apply
water/solution on the
forward stroke and
release the trigger on the
backward stroke to pick
up water/solution. For a
dryer finish, follow with an
additional dry stoke with
no trigger pressed.
USING YOUR MACHINE
Operation
IMPORTANT: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to
repeat the cleaning process. Make criss-crossing strokes across the original pattern and overlap with each pass. Do not over
saturate the carpet.
CAUTION: The brushbar constantly rotates when switched on and the machine is reclined. Never use on one spot for an
extended period of time as the brushbar may damage the floor surface.
Turn the rinse/wash dial
to WASH. The SpinScrub
brushes and brushbar
deep cleans your carpets
with water and solution,
removing dirt and stains.
Plug the machine into the
mains and press the On/Off
pedal to switch on.
Choose the cleaning
mode by turning the dial
on the base.
Quick Clean Mode:
Best for a quick, surface
clean - carpets dry in as
little as 1 hour.*
Deep Clean Mode:
Best overall results for
a thorough, deep clean.
*Tested in Quick Clean mode. Results may vary.
To Next Page
Loading...
