Tipping the cleaner and breaking the seal of the
nozzle against the carpet will cause the float to rise
cutting off suction. Once the float is activated, empty
the dirty water tank. If the tank does not appear full
turn off the power switch and wait for the float to
settle. For best results use only Vax Solution.
You will hear a change in motor pitch when the tank is full
and needs emptying.
Grasp the to
p of the dirty water tank handle and press
the release latch. Pull to remove from the base, take
care to ensure that no dirty water leaks from the front
(Fig 4/10).
Remove dirty water tank (Fig 4/11).
To empty the water tank grasp the handle with one hand
and nozzle with the other and empty into the sink
(Fig 4/13).
Rinse the dirty water tank and top thoroughly, with warm
water (Fig 4/14).
You should allow them to dry fully before replacing them
o
n your cleaner to prevent mildew.
Do not use any chemicals in the cleaning process.
Lift the front of the carpet cleaner base off the carpet
with one hand.
Grasp the handle and hook the front of the dirty water
tank into the base, making sure that the front of the
dirty water tank is resting on the base.
Failure to install the dirty water tank correctly will result
in poor dirty water pick up (Fig 4/15)
.
Fig.4/11
Fig.4/14
Fig.4/15
Fig.4/13
Fig.4/10
!
Cleaning the dirty water tank
Replacing the dirty water tank
NOTE: The float in your Rapide is located in the lid
of the dirty water tank. It will shut off the suction
when the dirty water tank is full. For best results
use a smooth steady motion keeping the nozzle
flat against the carpet.
IMPORTANT: Unplug your cleaner before
emptying the dirty water tank.
To Next Page
Loading...
Need help?
General
