Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause: On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Dirty water tank is full.
Solution: Switch off and unplug cleaner. Empty dirty water tank as shown on page 6.
Cause: Dirty water tank not installed correctly.
Solution: Refer to page 6 for fitting information.
Cause: Obstruction in hose/nozzle.
Solution: Remove hose and clear obstruction.
Cause: Dirty water tank is full.
Solution: Switch off and unplug cleaner. Empty dirty water tank as shown on page 6.
Cause: Dirty water tank not install
ed correctly.
Solution: Refer to page 6 for fitting information.
Cause: Solution tank not installed correctly.
Solution: Make sure the tank is securely locked in place
Cause: Solution tank not installed correctly.
Solution: Make sure the tank is securely locked in place.
Cause: Solution tank empty.
Solution: Refill tank. Refer to page 4/5 for instructions.
Cause: Handle not fitted correctly.
Solution: Ensure
handle is fitted correctly.
PROBLEM: The cleaner won’t run.
PROBLEM: Cleaner won’t pick up/loss of suction.
PROBLEM: Liquid escaping from the carpet washer.
PROBLEM: Clean solution won’t dispense.
To Next Page
Loading...
