To Next Page

To Previous Page

716

Slow Pulse = Charging

(Continuous during charge cycle)

Fast Blink = Error

(15 seconds duration for error code)

LED Illumination

Any other servicing should be done by an authorized service representative. If appliance is not

working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it

to a service center prior to continuing use.

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION

Vacuum won't run

1. Battery not charged. 1. Charge battery for up to 3 hours. The

indicator lights will pulse while charging and

turn off once fully charged.

2. Battery dead - won’t hold

charge.

2. Contact customer service. Visit our website

at www.dirtdevil.com or

call 1-800-321-1134.

3. Needs service. 3. Contact customer service. Visit our website

at www.dirtdevil.com or

call 1-800-321-1134..

Charger indicator

flashes and then

goes out

1. Problem with the charging

circuit

1. Contact customer service. Visit our website

at www.dirtdevil.com or

call 1-800-321-1134.

To reduce the risk of personal injury - Turn off before cleaning or servicing.

WARNING

at www.vax.com.au or

call 1300 VAX AUS.

TROUBLESHOOTING

Any other servicing should be done by an authorized service representative. If appliance is not working as

it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a service center prior

to continuing use.

Vax Reach VX92 User Manual

Questions and Answers: