Vax Steam Fresh COMBI User Manual

Using your machine
To produce steam squeeze
the trigger. To prevent
over wetting the carpet,
avoid holding the
trigger continuously.
Move the steam mop slowly
backwards and forwards
across the carpet paying
particular attention to high
trac areas.
To release the carpet glider,
place foot on clip and push
down. Lift steam mop to
unhook and remove.
Refreshing carpets
To recline the steam mop
place foot on oorhead and
pull handle backwards.
Place foot on outer oorhead
and gently pull away steam
mop to release the compact
scrub brush.
Move steam mop back and
forwards across the oor,
getting into corners and
awkward places.
Using compact scrub brush
IMPORTANT: When using on carpets, always make sure the microbre cleaning pad is used and covers the oorhead entirely
before using the carpet glider. Only use the carpet glider when refreshing carpets and turn the detergent dial to OFF.
Turn the detergent dial to OFF
when refreshing carpets.
Place the microbre pad on
the oor white side facing up.
Place steam mop onto pad
making sure the entire pad
covers the oorhead.
With microbre pad attached,
hook the steam mop into the
front of the carpet glider and
push to clip into place. Carpet
glider should only be used
when refreshing carpets.
Push On/O button
to switch on.
IMPORTANT: Always switch o the steam mop before attaching or removing the oorhead.

Vax Steam Fresh COMBI Specifications

General

Power	1600W
Heat Up Time	20 seconds
Model Number	S86-SF-C
Steam Time	15 minutes
Cord Length	8m