Taking care of your machine
Replacing the hard water lter
Pull to remove the
hard water lter.
Insert new lter, new lter
looks beige/cream in colour.
Remove the water tank
to access the hard
water lter.
IMPORTANT: Don’t operate the steam mop without the hard water lter in place. The condition of the lter aects the performance
of your machine, check and change the lter periodically. If you live in an area of hard water the lter will discolour or darken over time.
Depending on water hardness and frequency of use, the lter should be changed every 3 to 6 months or if the lter has discoloured.
If there is an obstruction
to the steam ow through
the machine, steam may
be released through the
bleed valve located on
the side of the handheld.
With the pad removed from
the oorhead, insert
a small thin object such
as a paper-clip in to the steam
holes to remove a blockage.
To remove the oorhead from
main body push the oorhead
release button and lift.
After oorhead is removed,
using a thin object such as
a paper-clip (in the area
shown), insert to remove
the blockage.
Removing blockages
Hard water lter should
be replaced every 3 to 6
months or if discoloured.
3-6 Months
IMPORTANT: Ensure machine is unplugged before carrying out maintenance
To Next Page
Loading...
