Taking care of your machine
Press the water tank
release button and lift the
water tank by the handle.
Emptying the water tank
Pull the tab on the
water tank to open.
Hold corner of pad down
with foot and lift steam
mop to peel away.
All cleaning pads are machine
washable (Max 40°C). Allow
to fully dry before use.
Removing cleaning pads
Max 40°C
IMPORTANT: Allow the steam mop to fully cool down before performing any maintenance or troubleshooting checks. Don’t leave
water or detergent in the tanks between uses, as this can eect the machines performance, the water/detergent tanks need to be
emptied and rinsed after each use.
Empty any excess
water into the sink.
Rinse water tank with
water and replace water
tank tab, push rmly to close
before replacing back onto
the machine.
Push both detergent tank
release buttons and lift
to remove.
Emptying the detergent tank
Twist detergent tank cap
anti-clockwise and lift
to remove.
Empty any excess detergent
over the sink.
Rinse detergent tank with
water and replace detergent
tank cap, turn clockwise to
tighten before replacing back
onto the machine.
To Next Page
Loading...
Need help?
General
