Taking care of your machine
Changing the belt
IMPORTANT: Unplug and switch o vacuum cleaner before maintenance or troubleshooting checks.
Using a crosshead screwdriver,
remove 3 screws from the side
of the oorhead.
Remove the end cap belt cover. Remove the brushbar location plate
to gain access to the belt.
Replace the old belt, ensuring the teeth
are fully engaged with the cogs.
Accessories
Don’t forget your accessories!
Order at: www.vax.co.uk/spares-and-solutions
TurboTool (Type 6)
1-1-134419
Use the TurboTool for vacuuming your stairs,
upholstery and car interiors. It’s great for
picking up stubborn pet hair.
3-in-1 Tool
1-1-129167
3-in-1 tool includes crevice tool for awkward
areas and corner, dusting brush for areas
such as skirting and an upholstery tool for
cleaning sofas, curtains, chair seats and
car interiors.
Pro cleaning kit
1-1-133326
All our best tools all in one kit that makes
cleaning your home quicker, easier and with
even better results. We’ve taken care of
cleaning all of the hard to reach areas such
as on top of cupboards and in between blinds
to the dust that collates behind and within
the radiator.
Turn the TurboTool over and
slide o the locking ring.
Detach lower housing
and remove.
Using a pair of scissors,
cut any hair or debris free
from around the brushes.
Removing blockages from the TurboTool
To re-assemble the
TurboTool, ensure that the
tabs are engaged and pivot
the lower housing closed.
Slip the locking ring over the
neck of the TurboTool and
into the groove to nish.
To Next Page
Loading...
Need help?
General
