Taking care of your machine
Taking care of your machine
Cleaning the shroud
Turn the dirt container lid
anti-clockwise and lift to remove.
Press button on post motor
lter cover and remove.
Tap over a bin to remove
dirt and debris.
Brush dirt from the shroud.
Remove the post motor lter
from the lter cover.
Check the post-motor lter
for discolouration.
tap
Switch o your vacuum cleaner
at the main socket. Using a pair
of scissors cut any hair or debris
free from around the brushbar.
Removing debris from the brushbar
A RED light will indicate
a jammed brushbar.
Turn the vacuum cleaner back on.
A
GREEN light will indicate that the
brushbar is clear and ready for use.
Changing the brushbar
Using a crosshead screwdriver,
remove 3 screws from the side
of the oorhead.
Remove the end cap belt cover. Remove the brushbar location
plate to gain access to the belt.
Replace the old belt, ensuring the
teeth are fully engaged with the cogs.
Pull brushbar through brushbar
side cover to remove.
PULL
HEPA post-motor lter maintenance
CAUTION: To reduce the risk of electric shock, turn the vacuum cleaner o and unplug from the electrical outlet
before performing maintenance/troubleshooting checks.
IMPORTANT:
The exhaust lter is designed to oer long life with no maintenance. The lter should be
checked periodically and when heavily discoloured it should be replaced. Please do not
wash, scrub or brush the lter as this will damage the delicate lter media.
IMPORTANT: Unplug and switch o vacuum cleaner before maintenance or troubleshooting checks
To Next Page
Loading...
Need help?
General
