5. The washing tool is flat on the surface
being washed.
6. The power control is correctly
adjusted within the washing
range. Turn higher than
minimum wash setting for
uneven or higher pile if required
(Fig/12.4).
7. There are no kinks in the solution tube.
Remove kinks by rubbing the tube between
finger & thumb
8. That the recovery bucket is not full, causing
the automatic cut off valve to stop the
suction.
3
2. Parts Checklist
10
12. If You Have
Washing Difficulties
IF YOU HAVE WASHING DIFFICULTIES,
CHECK...
1. The pump washing button is switched on.
2. The tube valve
is properly
connected
(Fig/12.1).
Before using your VAX, please read ‘Important safety information’ on page 2.
All VAX Multifunctions include:
3. The weight on the end
of the solution tube is
at the bottom of the
water reservoir and
not trapped between
the motor and water
reservoir (Fig/12.2).
4. The rocker
switch is
positioned
t o w a r d s
the back
(Fig/12.3).
13. Looking After Your VAX
Items below are available from your Vax
Retailer or from VAX direct.
REGULARLY (when you buy a new pack
of 5 disposable paper bags or 1 new
cloth bag)…
Replace cone filter
Available in a pack
of two. Also available
with a bondini filter and
exhaust filter in a 3 filter
pack.
Clean the
Bondini filter
Available with a cone
filter and exhaust filter in
a 3 filter pack. Wash filter
in warm water. Squeeze
it dry and replace it.
Your VAX will work more
efficiently if the Bondini filter is replaced with a
new one occasionally.
Clean the
exhaust filter
Available with a cone
filter and bondini filter in
a 3 filter pack. Wash filter
in warm water. Squeeze
dry and replace.
Other Accessories:
14. Looking After Your HEPA
Filter (Model Family VAX and Sukka only.
Optional extra with other models. Contact
VAXCARE for information)
1. Remove the HEPA
Filter by turning
a n t i c l o c k w i s e
(Fig/14.1).
To Next Page
Loading...
Need help?
General
