Vax Careline: AU: 1300 361 505
NZ: 0800 800 900
7
Operation
Recharging the battery
WARNING: To reduce the risk of injury from moving parts – turn power o (0=o), unplug charger and
then remove battery before servicing.
WARNING: Use only the charger supplied with the robotic sweeper. Do not use any other chargers. Risk of
re and personal injury can occur if any other charger is used.
NOTE: The robotic sweeper uses a charging timer so everytime you plug, and unplug it will start a new 4 hour
charging cycle. So if you charge it the light is solid green, then unplug it and plug it back in, the green led light
will ash and the robotic sweeper will charge for 4 hours again.
1. To ensure the best performance of the rechargeable battery and lengthen its life span, the battery is best used
after being fully charged for 4 hours every time. The charging function will be cut o automatically after
continuously charging for 4 hours.
2. Before charging , make sure the battery is correctly installed and the power switch has been turned to “OFF”
position (0=OFF).
3. To charge, plug the power supply (A) into a wall outlet and plug the end of the power supply to the charging port
(B) on the robotic sweeper.
4. When charging, the “CHARGE” LED indication lamp (C) on the control panel will ash green, and it will stay
green when the battery is fully charged.
5. When the battery is low, the “BATTERY LOW” LED indication lamp (D) on the control panel will light up
and stay RED.
NOTE: If you forget to turn o the power before charging, after the cleaner is fully charged, you have to switch o
the robotic sweeper and turn it on again to start cleaning.
TIP: To help ensure the robotic sweeper is ready to clean at its best, always clean the dirt cup and lter after each
use. Keep robotic sweeper plugged in and charging when not in use.
TIP: If robot has been in storage please charge prior to using to have it clean at its optimal performance.
To Next Page
Loading...
Need help?
General