Pull the lter tab
to remove the pre-motor
lter from the separator.
Tap separator over
a bin allowing
dirt/debris to fall out.
TA
P
MAX
40˚C
24hr
Tap the lter over
a bin to remove any
dirt/debris. Wash the
lter under running
water (40 degrees max).
Leave for 24hrs
or until fully dry
before replacing.
Ret the pre-motor lter
and separator.
Cleaning the separator and pre-motor lter
CAUTION: For best cleaning results lters require cleaning every 4-6 uses or as needed.
Do not use your handheld cleaner without the lter in place.
Using a dry cloth or soft
dusting brush remove any
dust/debris from
terminals on battery
charger, battery and
handheld cleaner.
Cleaning terminals
Taking care of your machine
Let’s talk technical
TIP
Replace lters every 6-9 months.
To Next Page
Loading...
