Using your machine
Filling the water/solution tank
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT: Your dirty water tank is tted with a oat. When the dirty water tank is full, or the oorhead is not in contact
with the carpet the oat will shut o the suction on the carpet washer. You will be able to hear if this has happened as the
motor noise on the machine will increase. Once the oat is activated, empty the dirty water tank if full. If the dirty water tank
is not full then turn o your machine at the power switch and wait for the oat to settle.
Press clean water/
solution tank release
button, pull and lift to
remove tank.
Tilt clean water/solution
tank and line up onto
carpet washer.
Push tank back until
it clicks into place.
Twist solution tank
cap anti-clockwise
and remove.
Turn wash/rinse dial to
‘wash’. The SpinScrub
brushes and brushbar
deep clean your carpets
with water and solution
removing dirt and stains.
Fill the clean water tank
with warm water
(max 40’C).
Pour required amount
of carpet cleaning
solution into tank.
Tighten cap before
returning tank to unit.
Plug into mains,
press the On/O
button to switch on.
TIP
This machine has an auto
mix tank so any solution
not used can be poured
back into the bottle.
To Next Page
Loading...
Need help?
General
