Taking care of your machine
Removing blockages from brushbar and SpinScrub brushes
Remove both tanks and tilt
carpet washer back.
Lift nozzle release clip
and pull nozzle forward,
separating tabs on nozzle
and carpet washer.
Rinse nozzle under water
to remove dirt/debris.
Replace nozzle by lining
up tabs on nozzle with
tabs underneath front
of carpet washer. Push
nozzle down until it clicks
into place.
Removing and cleaning the nozzle
Using a pair of scissors
remove any threads or
hair caught around
the brushbar.
Using a crosshead
screwdriver remove the
bottom screws from each
of the rug guards (metal
pins) so the bottom of the
pin is released. Unclip the
top of each to release
Firmly pull sides
of SpinScrub cover
to remove.
Remove any threads or
hair caught around the
brushes, rinse under
water to remove debris.
To Next Page
Loading...
Need help?
General
