What to do if it goes wrongWhat to do if it goes wrong
• Check the ‘This pack contains’ panel on the box to make sure the part
is denitely included in your unit.
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug if this needs replacing, always replace with
a British 13amp fuse.
• The oat in the dirty water tank may have been activated. Empty the dirty
water tank wait for the oat to settle before re-starting your carpet washer.
• The accessory hose connector cover has not been correctly closed.
Correctly close cover.
• Check the SpinScrub brushes and brushbar for blockages and clear.
• The dirty water tank may not be tted correctly. Re-t making sure
the lid is pushed down securely. Go to ‘Taking care of your machine’.
• Check the nozzle for blockages and clear. Go to ‘Taking care
of your machine’.
• Check the nozzle is correctly tted. Go to ‘Taking care of your machine’.
• Make sure the clean water tank is tted securely. Go to ‘Using your machine’.
• Wash/Rinse dial has been set to Rinse, set dial to wash to dispense solution.
• The clean water tank valve may be stuck, hold the clean water tank over the
sink and press the valve underneath to release.
• The brushes will only spin when the carpet washer is reclined.
• Check the SpinScrub brushes and brushbar for blockages and clear.
• Check for damage to the brushbar and the spindle on the back of the
SpinScrub brush cover.
SolutionProblem
CAUTION: To reduce the risk of personal injury, unplug the carpet washer before performing maintenance/
troubleshooting checks.
Is there an
accessory missing?
Why won’t my carpet
washer turn on?
Why won’t the
solution/clean
water dispense?
Why won’t my carpet
washer pick up?
Why won’t the
brushes spin?
To Next Page
Loading...
Need help?
General
