Vax W90-RU-B

Operation
vax.co.uk
7
Operating your carpet washer
Fill clean water tank
with solution mix.
Pour required dose of
cleaning solution
(approx. 40ml per 1L
of water).
Mix solution with warm
water. (max. 40˚C)
Remove clean water
tank.
Unwrap power cord and plug unit in.
Recline the machine.
NOTE: When
machine is reclined
brushbar will rotate.
Upright position
brushbar will not
rotate.
Press trigger to
release solution.
For best results apply
solution on the forward
stroke and and release
the trigger to recover
solution on the
backward stroke.
Tighten cap before
returning tank to unit.
!
4
0° C
m
ax
NOTE: Your dirty water tank is fitted with a float. When the dirty water tank is full or the floor head
is not in contact with the carpet the float will shut off the suction at the floor nozzle. You will be able
to hear if this has happened as the motor noise on the unit will increase. Once the float is
activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your
machine at the power switch and wait for the float to settle before re-starting.
W90-RU & W89-RU Series User Guide v1.4.qxd:User guide 2/3/11 10:04 Page 7